How To Install A Hollow Core Door
How to Supersede an Interior Door
Updated: Jan. 24, 2022
Upgrade your interior spaces by replacing hollow-cadre doors with sturdy, sound-reducing solid-cadre new interior doors. In this article we'll show you how to replace an interior door.
Replacing an interior door is easier than you remember. Learn how to do it yourself with this quick step-past-footstep guide.
You might also like: TBD
Measure the Existing Door and Doorframe
Take precise measurements of the existing door and doorframe; so remove the swivel pins and lift the existing door out of the doorframe.
Mark and Trim the New Door
If needed, mark and carefully trim the bottom of the new door to fit the existing doorframe. We used a table saw, but a round saw will too do the job.
Utilise the Existing Door as a Guide
Place the existing door on top of the new door. Marshal the height border of both doors, and utilise the existing door as a guide for marking the swivel placement on the new door.
Mark the Swivel Placement
Use a speed square to marking the top and bottom of each swivel on the new door.
Mensurate the Distance from the Edge
On the old door, measure the distance from the edge of the door to the edge of each hinge. Use the same measurements for each swivel on the new door.
Trace the Hinges
Line upwardly each hinge inside the marks on the new door and trace the outline.
Score the Mortises
Prop the new door on its side and use a abrupt utility knife to score the mortise for each hinge. Continue a steady mitt around any curved marks to make information technology easier to chisel out those areas.
Chisel Out the Hinge Mortises
Use a steady paw to chisel out the mortises for each hinge. Go on scoring the mortises with a utility knife every bit yous remove layers of wood.
Tap the Hinges in Place
Continue checking your progress as you chisel out the mortises. Use a cake of forest to protect the hinges every bit you tap them in identify.
Use a Door Lock Installation Jig
We used a door lock installation jig to bore holes in the slab for the latch and lever. The one shown in the photograph screws onto the side of the door and includes two hole saws.
Bore Holes for the Latch and Lever
Use the existing door as a guide to measure the distance from the peak of the door to the center of the latch. Then line up your door lock installation jig with that marking. Use the included hole saws to bore holes for the latch and lever.
Avoid Tearout
When you've cut about 3/4 of the way through the door for the lever, pull out the pigsty saw and cut the balance of the style through from the underside. This will aid to avoid tearout, which could harm your new door.
Mortise the Latch Plate
The jig we used included a handy template and cutting bit for mortising the latch plate. The bit removed some textile while creating an outline for the mortise.
Chisel Out the Latch Plate Mortise
Use a sharp chisel to remove the remainder of the material for the latch plate mortise. When all of mortises are created, seal all of the bare forest with a glaze of paint that matches the door.
Install the Latch and Lever
Spiral the latch and lever in identify following the manufacturer's instructions.
Screw on the Hinges
Mark the center of each screw hole; then secure the hinges in place with screws. Apply a cocky-centering swivel bit to ensure that the screws remain centered as you lot drive them. And so install the new door in the doorframe. Then repeat these steps for installing all of your new interior doors.
Originally Published: Jan 24, 2022
Source: https://www.familyhandyman.com/project/how-to-replace-an-interior-door/
Posted by: vickreytheacce46.blogspot.com
0 Response to "How To Install A Hollow Core Door"
Post a Comment